0
settings
الوضع الليلي
moon
انماط الصفحة الرئيسية arrow
EN
1
المرجع الالكتروني للمعلوماتية

علم الكيمياء

تاريخ الكيمياء والعلماء المشاهير

التحاضير والتجارب الكيميائية

المخاطر والوقاية في الكيمياء

اخرى

مقالات متنوعة في علم الكيمياء

كيمياء عامة

الكيمياء التحليلية

مواضيع عامة في الكيمياء التحليلية

التحليل النوعي والكمي

التحليل الآلي (الطيفي)

طرق الفصل والتنقية

الكيمياء الحياتية

مواضيع عامة في الكيمياء الحياتية

الكاربوهيدرات

الاحماض الامينية والبروتينات

الانزيمات

الدهون

الاحماض النووية

الفيتامينات والمرافقات الانزيمية

الهرمونات

الكيمياء العضوية

مواضيع عامة في الكيمياء العضوية

الهايدروكاربونات

المركبات الوسطية وميكانيكيات التفاعلات العضوية

التشخيص العضوي

تجارب وتفاعلات في الكيمياء العضوية

الكيمياء الفيزيائية

مواضيع عامة في الكيمياء الفيزيائية

الكيمياء الحرارية

حركية التفاعلات الكيميائية

الكيمياء الكهربائية

الكيمياء اللاعضوية

مواضيع عامة في الكيمياء اللاعضوية

الجدول الدوري وخواص العناصر

نظريات التآصر الكيميائي

كيمياء العناصر الانتقالية ومركباتها المعقدة

مواضيع اخرى في الكيمياء

كيمياء النانو

الكيمياء السريرية

الكيمياء الطبية والدوائية

كيمياء الاغذية والنواتج الطبيعية

الكيمياء الجنائية

الكيمياء الصناعية

البترو كيمياويات

الكيمياء الخضراء

كيمياء البيئة

كيمياء البوليمرات

مواضيع عامة في الكيمياء الصناعية

الكيمياء التناسقية

الكيمياء الاشعاعية والنووية

الكيمياء الجنائية

أساسيات كيمياء الأدلة الجنائية

الأدلة الجنائية

تحليل المخدرات

تحليل السموم

البصمة الكيميائية

قم بتسجيل الدخول اولاً لكي يتسنى لك الاعجاب والتعليق.

Installing, conditioning and maintaining columns , Column installation

المؤلف:  Sue Jickells , Adam Negrusz (Editors)

المصدر:  Clarkes Analytical Forensic Toxicology

الجزء والصفحة:  479

2026-11-21

49

+

-

20

Installing, conditioning and maintaining columns

Column installation

A GC column is attached at one end to the injector and at the other end to the detector. Attachment is typically via a nut and ferrule, the nut attaching to a screw thread on the injector and detector. As the nut is tightened, the ferrule is compressed and helps produce a gastight fitting.

Glass columns must have straight smooth ends to allow them to fit into unions at the injector and detector using either graphite or Vespel (polyimide) ferrules inside the nuts. Fused-silica capillaries should also have their ends freshly cut after insertion through ferrules, to eliminate blockages. The injector end of the column should be fitted first, adjusting the   height of the protrusion above the ferrule into the injector according to the type of inlet being used (this information is supplied by the GC manufacturer for the particular system in use), then tightening the fittings just enough to prevent leakage when tested with a proprietary leak-testing fluid (not soap solution which leaves a residue). The detector end of a packed column can be attached to a bubble-flow meter to ensure adequate flow through the column before connecting the detector end. The detector end of the capillary column may be immersed into a small tube of methanol to ensure adequate flow and the capillary end re-cut and then attached to the detector and checked for leaks. The detector is activated and the column tested at room temperature with an injection of 1 or 2 μL of methane, when a needle-sharp peak should be obtained. When the carrier-gas pressure has been adjusted to give a flow of approximately 20 mL/min of carrier gas for a packed column or 1 to 2 mL/min for a capillary, the column may be heated and a test mixture injected. Commercial columns are invariably supplied with a chromatogram obtained from a test mixture, and it should be possible to obtain a performance equal or close to the supplied chromatogram. Various test mixtures are used, including a mixture of dimethylphenol and dimethylaniline with straight-chain paraffins. Any acidity or alkalinity of the column is apparent by loss of the peak shape of the amine or phenol. The efficiency obtained is a function of the entire chromato graphic system. Poor efficiency or peak shape often results from a non-swept volume somewhere in the system.

It may be necessary to add an additional gas supply to the column outlet to ensure that the detector is purged effectively, because most detectors are designed to operate with packed columns and a flow rate of about 30 mL/min, as opposed to the 1 or 2 mL/min delivered by a capillary column. Make-up gas is integral in the design of most modern GC instruments.

اخر الاخبار

اشترك بقناتنا على التلجرام ليصلك كل ما هو جديد