0
settings
الوضع الليلي
moon
انماط الصفحة الرئيسية arrow
EN
1
المرجع الالكتروني للمعلوماتية

علم الكيمياء

تاريخ الكيمياء والعلماء المشاهير

التحاضير والتجارب الكيميائية

المخاطر والوقاية في الكيمياء

اخرى

مقالات متنوعة في علم الكيمياء

كيمياء عامة

الكيمياء التحليلية

مواضيع عامة في الكيمياء التحليلية

التحليل النوعي والكمي

التحليل الآلي (الطيفي)

طرق الفصل والتنقية

الكيمياء الحياتية

مواضيع عامة في الكيمياء الحياتية

الكاربوهيدرات

الاحماض الامينية والبروتينات

الانزيمات

الدهون

الاحماض النووية

الفيتامينات والمرافقات الانزيمية

الهرمونات

الكيمياء العضوية

مواضيع عامة في الكيمياء العضوية

الهايدروكاربونات

المركبات الوسطية وميكانيكيات التفاعلات العضوية

التشخيص العضوي

تجارب وتفاعلات في الكيمياء العضوية

الكيمياء الفيزيائية

مواضيع عامة في الكيمياء الفيزيائية

الكيمياء الحرارية

حركية التفاعلات الكيميائية

الكيمياء الكهربائية

الكيمياء اللاعضوية

مواضيع عامة في الكيمياء اللاعضوية

الجدول الدوري وخواص العناصر

نظريات التآصر الكيميائي

كيمياء العناصر الانتقالية ومركباتها المعقدة

مواضيع اخرى في الكيمياء

كيمياء النانو

الكيمياء السريرية

الكيمياء الطبية والدوائية

كيمياء الاغذية والنواتج الطبيعية

الكيمياء الجنائية

الكيمياء الصناعية

البترو كيمياويات

الكيمياء الخضراء

كيمياء البيئة

كيمياء البوليمرات

مواضيع عامة في الكيمياء الصناعية

الكيمياء التناسقية

الكيمياء الاشعاعية والنووية

الكيمياء الجنائية

أساسيات كيمياء الأدلة الجنائية

الأدلة الجنائية

تحليل المخدرات

تحليل السموم

البصمة الكيميائية

قم بتسجيل الدخول اولاً لكي يتسنى لك الاعجاب والتعليق.

Stationary phases and support materials Solid supports for packed columns

المؤلف:  Sue Jickells , Adam Negrusz (Editors)

المصدر:  Clarkes Analytical Forensic Toxicology

الجزء والصفحة:  p.476-479

2026-11-21

42

+

-

20

Stationary phases and support materials

Solid supports for packed columns

As noted above, in packed column GC where the stationary phase is a liquid, it is typically coated onto the surface of a solid support. The raw material for the most commonly used supports is diatomaceous earth, calcined, usually with a flux, then crushed and graded into a number of particle sizes (60–80, 80–100 and 100–120 mesh). Diatomaceous earths are available with a variety of properties and include the Chromo sorb series of supports. Chromosorb G has a surface area of about 0.5 m2/g, and is suitable for low-loaded columns – the amount of stationary phase should not exceed 5% (w/w). Chromosorb W has a larger surface area (1 m2/g) and accepts higher loadings, but is more fragile. Chromosorb P, obtained from crushed firebrick, accepts loadings up to 35% (w/w) for some phases. Supelcoport is the most inert of the diatomite supports, and can accept 20% (w/w) loadings. Carbopack, Porapak, HayeSep and Tenax-TA (see above) can also be used as solid supports. Table 18.3 shows the maximum suggested coating percentages for the most common solid supports. Deactivated support materials are nearly always preferred. Deactivation procedures include acid or base washing to remove impurities and fines, and treatment with a silanising agent that reacts with surface hydroxyl groups to reduce adsorptive effects. Support materials that have the liquid phase chemically bonded to them are available. These offer decreased bleed rates of stationary phase, an advantage when operating a temperature programme or when using a mass spectrometer as the detector.

اخر الاخبار

اشترك بقناتنا على التلجرام ليصلك كل ما هو جديد